Ok so i tried looking around online for some tutorials but couldn't find any on what i'm trying to do. I want to change the idle animation for power armor. I already have my 3 meshes that should change it but aren't doing anything. I believe it's because power armor equips weapons differently. So in short how would i go about setting it up for using my idle animation instead of the power armor setup. I went inside the GECK and tried to edit the power armor also and remove the tick that say's "backpack" but not sure if it did anything.

1. So i have my 3 meshes
2haaim
2haaimdown
2haaimup

2. They should go under
Data>Meshes>Character>_Male

but i get nothing from power armor only normal clothing and medium armor, everything but power armor.

Power Armor animations start with PA usually

A.J. wrote:

Power Armor animations start with PA usually

Do you mean in the GECK? Under what category/tab in the GECK

no, in general, i.e. pamtidle. Open the meshes.BSA and filter with _male\pa, if there are the files you need then probably you'll have to modify them to see the animation when wearing PA

A.J. wrote:

no, in general, i.e. pamtidle. Open the meshes.BSA and filter with _male\pa, if there are the files you need then probably you'll have to modify them to see the animation when wearing PA

I'm so sorry. I'm really confused. So i don't do this in the GECK? Do i make a new folder under meshes you mean? Because the only files under meshes>characters>_male are two folders idleanims and locomotion, then there are a bunch of animation files below that.


EDIT: FIXED BY RENAMING FILES TO SAME AS POWER ARMOR FILES AND REPLACING THEM

Quote :

FIXED BY RENAMING FILES TO SAME AS POWER ARMOR FILES AND REPLACING THEM

This I was meaning you were modifying the wrong files